|Current||5S BMS size||Remark|
|100A||150*66*25mm||Common port |
|120A||180*66*26mm||Common port |
|200A||211*120*32mm||Common port |
|250A||211*120*32mm||Common port |
B- Cable and P- cable size as below:
◆Use top quality (A-level) protective integrated circuit IC, from the solution of Seiko of Japan. IC itself has power balancing function. The circuit is simple and reliable.
◆Strong load ability, constant discharge current 100A 120A 200A 250A, , use high voltage resistance, low inner resistance power Mosfet. The heat sink will greatly help cooling.
◆Typical voltage detection for each cell. So each battery will be prevented over charged or over discharged. Over current and short circuit protection function is very reliable.Long time short circuit of the load won’t affect the PCB and the battery.Temperature protection during charging and discharging.
◆Extreme low power consumption. The consumption of the whole device is less than 50uA.
◆PCB use high anti-corrosion, high water resistance, high impedance ESD conformal Coating.
3. The Common Port Wire Connection & Separate Port it connection Way is Differet as Below:
◆ The cable starts from the black thin wire connecting B-, the second wire (the thin red wire) is connected to the positive pole of the first battery, and the positive pole of each battery is connected in turn until the last red wire is connected to B+;
◆ After connecting the wire, mustn't insert the plug directly into the BMS . Measure the voltage between each two adjacent metal terminals on the back of the plug. If the voltage of the terpolymer battery should be between 2.8V and 4.2V, the iron-lithium battery should be between 2.5V and 3.65V.
◆After correct wiring sequence and voltage confirmation, insert the BMS socket.
◆ The protective board B line (blue thick line) is connected to the negative pole of the battery pack.
◆ After the wiring is completed, measure whether the total voltage of the battery pack and the total voltage passing through the BMS are equal. If they are different, check again according to the above wiring sequence.
4. The BMS can be used to below tools:
5. The package picture as below only for reference, Please refer to the actual received phyical . The cable is free. Daly will send it to customer with BMS.
6. Daly has his own R & D team & Automachine production line. Not only does Daly have a hardware board, but now Smart BMSs are on the market. Daly's product quality has been tested by the market and customers can choose it which is right decision.
Factory address: No.92, Lihe Road,ShuiPing Village Dalang Town,Dongguan City, Guangdong Province ,China 523800